John bryan of the national trust describes this chart will give an admittedly simple-minded approach for the clock, a date indication. The red in the back of the case is from the flash, it's the same finish as the rest of the clock. He worked from 31 Prescot St, Goodmans Fields, London, between 1765 and 1788; Lombard St, to 1810 and George Yard, to 1812. The painted dial has a painted castle to the centre and decoration to the corners copied from the original dial. The red lead paint was used inside pine carcases which were veneered on the outside. I haven't seen anything that screams marriage for dial and movement, we all seem to be going in the right direction so far.
These earliest oak cases were simple by intent, partly because London styles which they copied in simplified form were themselves still simple, but partly because there was little point in offering a clock in cheaper materials if the sheer extravagance of styling made it into a costly clock anyway. Although carefully done, it was obviously replaced to remove inappropriately positioned winding holes and possibly a name. From around 1730 -1770 all these figures are approximate the brass dial clock was made all over England in ever-increasing numbers, and the dials became more ornate as time went on, especially on the eight-day clocks. Follow the simple instructions below and you'll soon get the hang of it. Any percentage guess as far as originality, or if I should run from it? Free heirloom plate frame movement, circa 1770.
Because of the short pendulum it could stand on a table, but the timekeeping was poor. Showing the time with beautiful blued steel hands and the makers name engraved to the arch. Arch dial spandrel, 1760 to 1785 16. Phases of the moon Shown on clock dials were introduced in c. I've seen the same clocks for sale for years, some I regard as old friends.
The corner painting is spreading a little too, and the imitation spandrels are now often geometric designs, or a fan shape, or a floral design, which fills the corner. As I uploaded the pics I realized I didn't take one of it together. Rococo pattern, used 1760 to 1785 15. The reason was essentially one of cost. I've seen it said that there were never cast iron weights on brass dial clocks but I'm not convinced anybody can have such certainty, but all of my clocks have lead weights.
Dial centres were matted till C. It has a very large brass faced Pendulum Bob and unusually, features an hourly strike on a bell. However, a signature may refer to someone other than the clockmaker. We would date this clock slightly earlier at around 1810. The clock features Strike - Silent to the arch, bell striking on the hour, calendar and seconds hands.
Keep in mind that no one list is complete. Entries provide working dates and a geographic location. A replaced seat board could mean a switched movement. Because the hands of the clock often broke and were replaced, the detail work in the spandrel offers a better option for dating the clock. Introduced to around 1700, which used to between. But it was not used in the same manner throughout that period of over two centuries.
In determining its age, it's important to include many factors other than just the name. Most of them only had one hand, because the average person had no need of knowing the time to the nearest minute, and with a bit of experience you can tell the time to the nearest five minutes on one of these early clocks. . Fully overhauled and is sold with a 12 month Guarantee. But it wasn't until about 1670 when clockmakers mastered the workings of the pendulum for accurate timekeeping in conjunction with an anchor escapement -- the mechanical device that gives a pendulum its swing.
By the 1770's the painted dial had been introduced and by 1790 the brass dial was being used in much smaller numbers. Fully overhauled and is sold with a 12 month Guarantee , delivery and set up free of charge within 70 miles of our shop. The majority of English grandfather clocks were made in The Midlands and the North of England. Until the 19th century clock cases were almost always made separately from the movement and are rarely signed. Gold spandrel corners date a grandfather clock to between 1775 and 1785. An eight-day clock of about 1750 in oak, made by the celebrated Thomas Ogden of Halifax, whose work was often housed in unusual cases. The panelled base with double plinth.
We cannot date this clock from the name on the dial, 2. The maker will likely be listed with a working date and possibly other useful information. We must judge whether they are contemporary, whether they belong together, and whether they likely started life together as one clock. Determining the back plate will give an english longcase clock by green and. Circa 1810 to 1820 Now we come to the later clocks, of around 1830 to 1880.